The lines aren't as sharp as they should be?
Answer:
depending on the graphics card you are using and the menu capability of your monitor,this can be easily rectify
both the nvidia control panel and the a.t.i catylyst control center have colour settings option were you can sharpen the display,you should first set your display colour settings to non-attendance and work from there,once you achieve the desired setting remember to apply and then press ok
also again depending on the kind and model of your monitor,press the menu button and using the multi-directional buttons( < , >)select the colour option,at hand should also be a reset to factory settingsoption,this will return the monitors settings to the instrument it was when you first ever used it
finally the worse overnight case scenario is your monitor(especially if its a c.r.t monitor)is on its way out
if this is the bag then you may newly have to put up next to it until you can replace it,monitors are very complex,well hard by on impossible to repair
i hope this helps
worthy luck mate!
Should change monitor rejuvenate rate to higher if at all possible. If a electrical power voltage is low, or a strong magnetic enclosed space is near
(speakers, magnet) this may happen too.
Adjust the brightness and contrast controls. On old monitors within are knobs to turn. Most modern monitors own on screen controls. If the monitor is awfully old later the colours fade with age.
No comments:
Post a Comment